Error E18 in Siemens washing machine

How to eliminate error E18 in Siemens washing machine?

  • Error: E18
  • Description: Water drainage problem.
  • Cause: 
  • Solution: -Descone the washing machine and unplug it from the current.
    -Car the water intake.
    -The lid where the filter is located.
    -Reet the filter plug and check its interior.
    -Revist the pump propeller located in the same hole as the filter in case it was stuck.
    -Incline the washing machine back and check the hose connected to the drain pump to see if it is folded or obstructed.
    -Revy the thick hose that leaves the Cuba.

If your Siemens washing machine is showing the E18 error on the display, it means that there is a problem in the drainage system. You may have also noticed that there is stagnant water in the drum. But don’t worry, in most cases, you can solve this problem yourself.

Reasons for the Problem

The reasons for the E18 error appearing on different models of Siemens washing machines are varied. It may be due to the pump being blocked or there being a kink in the drainage hose.

How to Solve the Problem

The first thing you should do is close the water valve so that no more water enters. Then, turn off the washing machine using the power button and unplug it. To find the cause of the problem and check the pump, you need to remove the remaining water in the drum.

Follow the steps

After removing the water, you can follow these steps to unblock the pump and solve the problem:

  • Step 1: Carefully unscrew the pump cover.
  • Step 2: Remove the pump cover.
  • Step 3: Clean the inside of any residue.
  • Step 4: Check that the drain pump impeller can spin freely.
  • Step 5: Reattach the pump cover and screw it in tightly. The pull tab should be vertical.
  • Step 6: Close the service cover.

To check if the pump has any leaks and if its power is sufficient, pour a liter of water into the detergent compartment and then start the drainage/drain cycle.

Checking the Drainage Hose

The E18 error can also be caused by a blockage or a bent hose. First, check if the drainage hose is bent or twisted, which can cause a blockage in the water flow. If this is the case, simply straighten the hose to solve the problem.

If the hose appears to be fine, disconnect it from the drainage.

  • Step 1: Turn off the machine.
  • Step 2: Before releasing the hose clamp in the siphon, place a bucket under the faucet to avoid splashing.
  • Step 3: Carefully remove the drainage hose and pour any water remaining in the hose into the bucket.
  • Step 4: Clean the drainage hose and the siphon connection. Lint, buttons or coins can block the siphon.
  • Step 5: Remove the hose connector and check it.
  • Step 6: If there is no obstruction, reconnect the drainage hose and the clamp.

What to Do If the Problem Persists?

After performing the above actions, your washing machine should pump and drain the water correctly. If the problem persists, it may be due to a pump defect or other reasons.

In this case, it is necessary to call an expert from the Siemens Integral Service to repair the washing machine.

Remember that it is always important to follow the instructions in the user manual and take safety measures when handling the washing machine, such as turning it off and unplugging it before performing any checks or repairs.

Other error codes in Siemens washing machine

Error F27 in Siemens washing machine

Error F27 in Siemens washing machine

What to do when the error appears: Water supply problem ...
Error F29 in Siemens washing machine

Error F29 in Siemens washing machine

What to do when the error appears: Water supply problem ...
Error F17 in Balay washing machine

Error F17 in Balay washing machine

What to do when the error appears: Water supply problem ...