If your Beko dishwasher presents the E02 error, the first thing to do is to check the water inlet and filter.
Steps to follow to solve the E02 error:
- Check the water inlet: Make sure the water inlet is open and the water supply is working properly. If the water inlet is clogged or closed, the dishwasher will not be able to draw water.
- Check the filter: The filter is an important part of the dishwasher, as it helps prevent debris from entering the system. If the filter is clogged, the dishwasher will not be able to catch water. To check the filter, follow these steps:
- a. Turn off the dishwasher and disconnect it from the electrical power.
- b. Open the dishwasher door and remove the bottom basket.
- c. Locate the filter at the bottom of the dishwasher and remove it.
- d. Clean the filter with warm water and a soft brush.
- e. Put the filter back in place and make sure it is tight.
- Check the water inlet hose: The water inlet hose is the hose that connects the dishwasher to the water supply. If the hose is clogged or damaged, the dishwasher will not be able to draw water. To check the hose, follow these steps:
- a. Turn the dishwasher off and disconnect it from the electrical power.
- b. Locate the water inlet hose on the back of the dishwasher.
- c. Verify that the hose is connected properly and is not clogged or damaged.
- d. If the hose is clogged, clean it with warm water and a soft brush.
- e. If the hose is damaged, replace it with a new one.
- Check the water inlet valve: The water inlet valve is the valve that controls the flow of water into the dishwasher. If the valve is clogged or damaged, the dishwasher will not be able to draw water. To check the valve, follow these steps:
- a. Turn off the dishwasher and disconnect it from the electrical power.
- b. Locate the water inlet valve on the back of the dishwasher.
- c. Verify that the valve is open and that it is not clogged or damaged.
- d. If the valve is clogged, clean it with warm water and a soft brush.
- e. If the valve is damaged, replace it with a new one.
Our advice
If your Beko dishwasher has error E02, don’t worry. The solution is relatively simple and can be done at home with a little patience and attention. However, it is important to keep in mind that intervening on the dishwasher without warranty or returns can be dangerous and can cause major damage. It is therefore recommended to seek professional technical assistance to avoid major problems.
We hope this information has been useful and that you have been able to solve the E02 error in your Beko dishwasher effectively. If you have any questions or comments, feel free to leave them in the comments section below.
Other Beko dishwasher error codes
Beko Dishwasher Error Codes
When your Beko dishwasher starts acting up, it can be frustrating not knowing what's going on. Fortunately, most modern dishwashers, including those from Beko, are designed to display specific error ...
How to Fix Error H4 in a Beko Dishwasher
Error H4: Problem with the water heater Description: Error H4 in a Beko dishwasher indicates a problem with the water heater. It can be caused by a failure in the ...
How to solve Beko Dishwasher Error E01
Error: E01 Description: Dishwasher cannot fill with water. Cause: Problems with the turbidity sensor, bypass valve, temperature sensor, water meter and drain pump. Solution: Perform a function test to detect ...