- Error: “Samsung dryer not heating”
- Description: The dryer spins but does not heat.
- Cause: Burned-out heating element, blown thermal fuse, faulty thermostat, ventilation blockage.
- Solution: Check and replace the faulty component, clean the vent.
Is your Samsung dryer spinning but not heating, leaving you with a pile of damp clothes? Don’t worry, this is a common issue that many users face, and in many cases, you can fix it yourself without needing to call a technician. Here’s how.
First Steps
Check the Power or Fuel Source
Before you panic, make sure your dryer is receiving the proper power. For electric dryers, check that the circuit breaker hasn’t tripped. For gas dryers, ensure the gas supply is connected and active.
Preventive Maintenance
Take this opportunity to clean the inside of your dryer. Lint buildup can cause overheating and other issues. Also, make sure the exhaust ducts are not blocked.
Common Causes and Solutions
Blown Thermal Fuse
The thermal fuse is a safety device that trips if the dryer overheats. If this fuse burns out, the dryer will not heat.
Solution: Disconnect the dryer, locate the thermal fuse (consult the manual for its location), and check its continuity with a multimeter. If it’s burned out, replace it.
Faulty Heating Element
If your dryer spins but does not heat, the heating element might be burned out.
Solution: Disconnect the dryer and locate the heating element. Visually inspect it for damage or use a multimeter to check for continuity. If it’s defective, you’ll need to replace it.
Faulty Thermostat or Thermistor
A faulty thermostat or thermistor can prevent the dryer from heating properly.
Solution: Locate these components and use a multimeter to check their continuity. If either fails the test, replace it.
Obstructed Ventilation
Blocked ventilation can prevent hot air from circulating properly, resulting in clothes that don’t dry.
Solution: Clean the lint filter and ensure the ventilation duct is not obstructed. Make sure air flows freely from the dryer to the outside.
Samsung Dryer Reset
If your Samsung dryer displays an error code or just isn’t functioning as it should, a reset might be the solution.
How to reset: Unplug the dryer or turn off the power from the circuit breaker. Wait a few minutes for any residual electrical charge to dissipate, and then reconnect it.