Hoover is a brand of washing machines that specializes in manufacturing high quality washing machines. Hoover offers a wide selection of washing machines to meet the needs of any household.
Hoover Washer Error Codes
The Hoover washing machine is a high quality brand of washing machines. However, errors can sometimes occur. Below is a table of the most common errors in Hoover washing machines.
| Error code | Error description | Solution |
|---|---|---|
| E01 | Problem with door lock. Problem with UBL (washer door locking device). The door does not close when it is closed. And key indication does not occur. | Possible damage to the door lock. You should check it, as well as the integrity of the wiring. It is also worth making sure that the electronic controller is working properly. |
| E02 | Problem with water filling. Problem with water collection. Water may not be entering the washer tank. The amount of water during the set time does not reach the desired amount. That is, it is less than what is needed to complete the program. The amount of water needed to complete the program is exceeded. | There is an obstruction or blockage in the fill valve. The fill valve is out of service. The level sensor (level switch) or its connections are damaged. The electronic controller is broken. Check that the water inlet filter is not clogged. |
| E03 | Problem with the drain. Water does not come out of the washer at all or very slowly. | There has been an interruption or violation of the drain pump wiring or it has failed. The level sensor in the washing machine has become unusable. For example, it may give incorrect signals. The drain system may be clogged. Clogged drain pump nozzles, hose or filter. |
| E04 | There is a problem with the fill valve. The amount of water in the washer tank required to run the program has been exceeded. The level switch indicates that there is too much water in the machine tank. After three and a half minutes, an error occurs on the display. – Excess detergent in the washing machine | The fill valve is stuck in the open position and water continues to be drawn despite the fact that a signal was sent to stop dialing. A controller that regulates the operation of the fill valve could also fail. |
| E05 | Problem with the temperature sensor. No heating of the water to the required temperature. Error “E05” appears on the display. | The heating element (TEN) or its wiring and contacts failed. The controller may also be broken. The temperature sensor has become unusable. When checking with a tester (multimeter), make sure that the resistance is approximately equal to two tens of ohms at an average room temperature. You must make sure that the program selector motor is operating properly. The voltage required for operation is 220 volts. The winding resistance is approximately equal to 15 kOhm. In addition, you must ensure that the display and control units are functioning properly. |
| E07 | Excessively fast operation of the electric motor Three attempts to start the electric motor of the washing machine. And then the washing process is interrupted and the inscription “E07” appears. | The tachogenerator is broken. The resistance to the winding of this part (if it is working) is approximately equal to forty-two ohms (if the engine CEZET).and for the electric motor HOOVER: 156 ohms. Often, this malfunction appears due to the failure of the technical generator core. If it collapsed. |
| E09 | There is a problem with the electric motor of the washing machine: the motor shaft does not rotate. An error occurs, the designation of which you can see in the next column. The automatic tests continue. | Damage to the control unit or triac failure. |