E16 error on the Balay 3TS60107 washer: causes and fix

The E16 code on the Balay 3TS60107 washing machine generally means that the appliance cannot correctly detect that the door is closed. If it appears as soon as the selector is turned, before any program starts, the problem is usually in the door interlock or its safety circuit, rather than in washing or water intake.

A reset may clear a temporary lockout, but it cannot repair a worn interlock, a loose connector or damaged wiring. On this 6-kilogram model with a maximum spin speed of 1,000 rpm, the warning may remain from startup because the control board checks the closed-door signal immediately.

If you have a problem with your washing machine, you can use our free error code finder. From there, you can identify and solve all errors easily and effectively.

What E16 means on this Balay model

The door lock is not just a mechanical latch. It contains a small switch and, on many models from the BSH group, a component that physically locks the door when the cycle begins. The electronics need to receive a precise signal; without it, the machine prevents the drum from turning and displays a door unlocked or incorrectly closed error.

The simplest cause may be clothing trapped between the seal and glass, a door that does not fully engage or detergent residue around the latch. The handle may also have developed play. However, when the code appears without pressing start, a faulty door interlock, intermittent connection or control issue becomes more likely.

The 3TS60107 is approximately 848 by 598 by 550 millimeters and uses a 220-240-volt supply. These figures do not make diagnosis a job for improvisation: the locking area is connected to mains power, and an incorrect test can damage the control board.

Safe checks before replacing parts

Disconnect the washer from the power supply for several minutes and check that the door closes without unusual resistance. Do not force it or pull the handle. Visually inspect the hook, seal and latch area for bending, obstruction or hardened detergent. Then reconnect the appliance and select a program without adding laundry.

If E16 returns immediately, the reset has already helped rule out a temporary lockout. Repeating button combinations or turning the selector again and again usually adds no useful information. The worthwhile inspection, with the washer unplugged, is the condition of the connectors and wiring leading to the door interlock device.

Do not bypass the interlock to make the appliance run. This component prevents the door from opening while the drum is moving and water remains inside. Besides creating an injury hazard, bypassing it can cause electrical damage and remove an essential safety protection.

When it points to the interlock or the electronics

Replacing the lock is a sensible option when the door needs a push to be recognized, the hook fails to hold its position or the code changes when the door is gently pressed. The replacement must match the exact model and electrical configuration; physical fit alone is not enough.

If the component is sound, a technician should check continuity, terminals, wiring and the signal leaving the control board. A burnt connector, moisture or a broken conductor near the front panel can cause the same symptoms. The electronic control board should be considered only after those causes are ruled out, since replacing it without measuring the circuit can make the repair unnecessarily expensive.

Repair costs should be assessed by comparing the lock price, labor and the washer’s age. The model has practical household capacity and features such as a delay start of up to 24 hours, but no program can begin until the electronics confirm that the door is safely closed. E16 is not a message to conceal: it is a safety barrier and a clear starting point for diagnosis.