When your Amana dryer stops heating, it can be a real hassle. Clothes come out damp, and you’re left scrambling for drying alternatives. But don’t worry, we’re here to guide you through troubleshooting this issue step by step. Before you call in a technician, there are a few things you can check yourself.
- Error: «Amana dryer not heating»
- Description: The dryer turns on but does not produce heat, leaving clothes damp after a full cycle.
- Cause: It could be due to a defective heating element, thermal fuse, high-limit thermostat, cycling thermostat, or electrical supply issues.
- Solution: Check and replace the faulty component or resolve electrical supply issues.
Defective Heating Element
The heart of the dryer is its heating element. If this component fails, there will be no heat. To check it:
- Disconnect the dryer from the electrical outlet to avoid accidents.
- Access the heating element by removing the back or front panel, depending on your model.
- Visually inspect the element. If you see broken coils or burn marks, it’s likely you’ll need to replace it.
- Use a multimeter to check for continuity. If there’s no continuity, the element needs to be replaced.
Blown Thermal Fuse
The thermal fuse is a safety device that trips if the dryer overheats. To check it:
- Locate the thermal fuse, usually near the heating element or in the blower housing.
- Disconnect the dryer and remove the fuse.
- Check for continuity with a multimeter. Without continuity, the fuse is blown and needs to be replaced.
High-Limit Thermostat and Cycling Thermostat
These thermostats regulate the temperature inside the dryer. If they fail, they can prevent the dryer from heating properly.
- Disconnect the dryer and locate the thermostats, usually near the heating element.
- Remove the thermostats and check for continuity with a multimeter.
- If either of them lacks continuity at room temperature, you’ll need to replace it.
Electrical Supply Issues
An Amana dryer typically needs 240 volts to operate correctly. If there’s an issue with the electrical supply, the dryer won’t heat.
- Check the electrical supply with a multimeter. You should have about 120 volts in each leg, totaling 240 volts.
- If not, check your home’s breaker panel. You may need to reset the breaker or contact an electrician if the problem persists.
Other error codes
Errors or Error Codes for Electrolux Dryer
Errors or Error Codes of Siemens Dryer
