Magazine
Electric blanket energy use: watts and monthly running costs
Watts, hours and electricity rates: calculate running costs without confusing rated power with actual energy use.

A 100 W electric blanket uses 0.1 kWh when it runs for an hour at full power. At an example electricity rate of €0.15/kWh, that costs 1.5 cents per hour and €0.90 per month when used for two hours daily over 30 days. Common models are rated at roughly 50 to 150 W, although other sizes and power ratings are available. Running costs depend on power, time and electricity rates; if the temperature control interrupts heating, actual energy use may be lower.
If you have a problem with your electric blanket, you can use our free error code finder. It helps you identify and resolve errors easily and effectively.
The watts on the label are not your monthly energy use
Power describes how much electricity an appliance draws while operating under particular conditions. It is expressed in watts, shown by the letter W. The energy recorded on your electricity bill is expressed in kilowatt-hours, or kWh. That distinction matters: a 100 W blanket does not use 100 kWh or need an hour to reach that power. Its energy use depends on how long it keeps heating and how its controls operate.
To translate the label into energy use, the calculation is straightforward: energy in kWh = power in W ÷ 1,000 × operating hours. A 60 W model running for an hour therefore uses 0.06 kWh; a 150 W model uses 0.15 kWh under the same conditions. These figures assume continuous operation at the stated power, rather than predicting the exact consumption of every session.
There is another common mix-up involving appliance specifications. Watts measure power; volts measure electrical voltage. A reference to 24 W does not describe voltage or prove that a product is safer. For running-cost calculations, the relevant figure is the input power specified by the manufacturer. Safety depends on the design, protective features and intended use described in the manual.
From single to double: figures that make comparison easier
As a guide, single electric blankets and heated underblankets are often rated at around 60 to 100 W, while double models may be rated at 100 to 150 W. Products outside those ranges also exist, so size is no substitute for checking the specifications. Two similarly sized blankets can have different maximum power ratings, heat distribution and different temperature control systems.
The following comparison uses a hypothetical electricity rate of €0.15/kWh and two hours of daily use over 30 days. It does not represent a current tariff or assume that a thermostat keeps the heating element on continuously. Its purpose is to compare models under the same calculation conditions, without assigning savings that have not been measured.
| Stated power | Energy in one hour at full power | Energy over 30 days, two hours daily | Monthly cost at €0.15/kWh |
|---|---|---|---|
| 60 W | 0.06 kWh | 3.6 kWh | €0.54 |
| 100 W | 0.10 kWh | 6 kWh | €0.90 |
| 120 W | 0.12 kWh | 7.2 kWh | €1.08 |
| 150 W | 0.15 kWh | 9 kWh | €1.35 |
On double models with independent controls, the label may state the combined power or give a separate rating for each zone. Check which figure you are reading before multiplying it. Using just one side may reduce energy consumption when the design allows it, but does not guarantee an exact halving: the result depends on the power and regulation of each circuit.
The price per kWh changes the calculation significantly
The variable running cost is energy used multiplied by the applicable price per kWh. A 100 W blanket used for two hours daily over 30 days consumes 6 kWh if it runs without interruption. At €0.15/kWh, that costs €0.90; at €0.55/kWh, it costs €3.30. Both prices are calculation examples, not current market benchmarks. The difference comes from the electricity rate, not the blanket.
The relevant price appears in your contract terms and bill breakdown. If it varies by time of day, apply the rate for the hours when the blanket is used. With variable prices, a more accurate calculation separates consumption by period. Night-time use cannot automatically be assumed to cost less: cheaper hours depend on your contract and, where applicable, the energy price at each particular time.
To estimate the additional amount on your bill, distinguish between charges that increase with consumption and costs you already pay even when the blanket is off. A fixed charge for contracted power does not rise simply because you use it. Taxes and other items may need adjusting depending on how the price is presented. Using a tax-inclusive rate and then adding those taxes again would produce an artificially high estimate.
Cents per session should not be confused with cents per month, either. In the example of 100 W used for two hours, daily energy consumption is 0.2 kWh; after 30 days, it totals 6 kWh. Leaving out that monthly multiplication makes the cost misleadingly low. Keeping daily and monthly costs separate prevents many of the errors found in claims about these appliances.
The thermostat explains why actual consumption may be lower
An electric blanket produces heat through resistive elements distributed through the fabric. Depending on the model, its control system may alter the power supplied, interrupt heating or combine both approaches. A 120 W label therefore does not necessarily mean the appliance draws that power throughout a session. The rating provides a useful reference scenario, but does not describe every operating moment.
Initially, the appliance has to warm fabric that is cold. Afterwards, maintaining a moderate temperature may require less energy than that initial warm-up. The selected setting, surrounding temperature and manufacturer-approved way of using it all matter. There is no universal thermostat saving percentage: assuming it always operates for half the time introduces a level of precision without justification.
Choosing the middle setting does not guarantee using exactly half as much energy as the highest setting. Control positions do not necessarily correspond to proportional power steps. To compare actual consumption, consider a complete session rather than a single moment during heating. The most useful figure is energy accumulated throughout the session, because it includes both the initial warm-up and later pauses in heating.
Preheating the bed and eight hours of use are different scenarios
A 100 W blanket running continuously for 30 minutes uses 0.05 kWh. At €0.15/kWh, that costs €0.0075, or 0.75 cents. Repeated over 30 days, it would cost €0.225, approximately €0.23. This is a preheating example, not a required duration: the appropriate time is set by the manufacturer for that product and its intended use.
If the same appliance ran for six hours daily at full power, it would use 18 kWh over 30 days and cost €2.70 at the same example rate. At eight hours daily, consumption would reach 24 kWh and the cost €3.60. The calculation helps put the expense in perspective, but does not authorise overnight use of a blanket that was not designed for it.
There is no universal monthly spending ceiling for every model, either. A 150 W blanket used for eight hours daily without interruption would consume 36 kWh over 30 days: €5.40 at €0.15/kWh. A higher electricity rate would increase that amount. Claims that any blanket costs less than two euros a month leave out essential variables. Low running costs still need context.
A timer limits operating hours and can prevent forgotten switch-offs, but it does not replace the instructions. Nor should an automatic safety shut-off be interpreted as permission to sleep with the appliance on. These are different functions: one manages use, while another may respond to particular conditions. What matters is explicit approval for the intended use in the instructions for that model.
A blanket warms a person, not the whole room
The energy advantage comes from directing a small amount of power towards a specific area. A 2,000 W fan heater running for an hour at full power uses 2 kWh; a 100 W blanket uses 0.1 kWh. That is a twenty-to-one ratio in this scenario. However, they do not provide the same service: one heats air while the other provides local warmth.
The comparison is useful for someone sitting and reading or wanting to warm a bed before getting in. It stops being equivalent when several people are moving around a room or an appropriate ambient temperature is needed. A blanket does not remove damp or solve a cold-home problem. The same consumption ratio cannot automatically be applied to a heat pump, either, because its operation is different from an electrical resistance heater.
Household savings depend on what actually stops being used. Adding a blanket while keeping the same heating schedule and settings increases consumption, even if only slightly. It may reduce total spending if it allows unnecessary heating use to be cut while maintaining suitable conditions for everyone at home. There is no universal saving percentage: the outcome depends on insulation, climate and individual needs.
Paying extra for low consumption may not pay back
Resistive electric blankets turn electricity into heat; no fabric can multiply the incoming energy on its own. Practical differences lie in heat distribution, how well the material insulates and how temperature is controlled. Accurate controls, independent zones and a timer can prevent unnecessary operation. The useful comparison is comfort delivered for the energy consumed, rather than an isolated marketing description.
Fewer watts do not automatically mean a better purchase. A small model may suit a localised area but be unsuitable for the surface you want to warm. A more powerful one may reach its selected setting sooner and then regulate its output. Power should be considered alongside size and approved use, without assuming that the lowest number always saves more in every situation.
If a blanket works correctly and remains in good condition, replacing it solely to lower electricity bills requires comparing the extra purchase cost with the possible savings. When existing running costs are only a few euros a month, a small reduction may take a long time to repay the purchase. Deterioration or unsafe conditions change that decision: safety is not a matter of cents saved.
A measured reading beats a general estimate
The label provides enough information for an initial calculation. If actual energy use is needed, a suitable plug-in energy meter can record the kWh consumed during a session, provided its use is compatible with both products’ instructions. It is used as an external accessory, without opening anything or altering connections. If there are concerns about compatibility or socket condition, do not improvise the connection.
The useful approach is to record energy over a representative period, using the usual setting and method of use. Looking only at watts while the blanket is heating can overstate consumption for the whole session; checking during a pause can understate it. Accumulated energy captures those variations. It is also important to distinguish your own measurement from an extrapolation: another room or setting may produce a different result.
The total consumption shown in a household energy app does not necessarily identify the blanket’s contribution. The fridge, lighting and other appliances may switch on during the same period. If a bill has risen sharply, attributing the whole difference to a 100 W appliance without checking its operating hours is a weak diagnosis. Multiplying power by time provides a useful consumption plausibility check.
The condition of the fabric matters more than saving one session
A heated throw, heated underblanket and heating pad are not interchangeable simply because they plug in. Each must be positioned as its manufacturer specifies, above or beneath the user according to its design. Do not switch the product on while folded, bunched up or creased in ways that concentrate heat. Do not add other heat sources without explicit approval: trapped heat can cause burns.
Before use, an accessible check means inspecting the fabric, cable and controller while the appliance is unplugged. Scorch marks, hardened patches, exposed parts, unusual smells or highly localised heating justify stopping use. Do not open the controller, repair wires with tape or search for internal heating elements. Beyond that point, the appropriate next step is assessment by an authorised technician, following the manufacturer’s guidance.
Cleaning requirements also depend on the model. One washable blanket does not mean another can go in a washing machine or tumble dryer. Only detach components specifically designed by the manufacturer to be removable, without interfering with the integrated wiring. After cleaning, the blanket must be completely dry before connection. Never use its heating function to dry it: moisture and electrical power must not coincide.
People with reduced heat sensitivity or who cannot operate the controller need particular care and an appropriate assessment of their circumstances. A blanket should not be used as a self-prescribed pain treatment when a relevant medical condition is present. There is no universal therapeutic duration suitable for everyone, either. In these cases, medical guidance and the product manual take priority over any saving calculation.
A small running cost still calls for a considered decision
A blanket feeling cooler than expected does not by itself prove a fault. Temperature regulation may be operating, the timer may have reached its limit, or the product may not suit the way it is being used. Users can check settings and instructions without taking anything apart. If a code appears, its meaning must be checked for that brand and that model, rather than inferred from another appliance.
When a fault recurs or there are signs of deterioration, repeatedly resetting an old blanket to keep using it is not a sensible saving strategy. Before buying a controller or spare part, compatibility and diagnosis need to be confirmed; a lack of heat does not identify the component responsible. If assessment or replacement is appropriate, check warranty terms and the full cost of the alternative, without assuming coverage.
Under normal conditions, the calculation starts with information on the label: watts divided by 1,000, multiplied by hours and the price per kWh. Expectations can then be adjusted for actual temperature regulation and permitted use. An electric blanket can provide warmth using little energy, but its value lies in heating where needed without running unnecessarily, not in promising the same bill for everyone.
This article contains affiliate links: if you buy through them, we earn a small commission at no extra cost to you. More information.
Magazine5 days agoReplacing boilers with heat pumps: CAE multipliers up to x6
Magazine7 days agoENISA warns home appliances could be the next cyberattack target
Boiler7 days agoBosch boiler faults: error codes, causes and what to do
Ariston7 days agoAriston electric water heater errors: meanings and solutions
Dishwasher6 days agoIndesit dishwasher errors: codes, lights and safe checks
Boiler7 days agoRoca boiler error codes: meanings and safe checks
Oven5 days agoSiemens oven error codes: meanings and safe solutions
AEG5 days agoAEG tumble dryer error codes: what they mean and what to do
Fridge5 days agoLiebherr refrigerator errors: codes, alarms and solutions
Candy6 days agoCandy tumble dryer error codes: warnings and safe checks
Boiler7 days agoTifell boiler faults: codes, causes and safe checks
Oven5 days agoSamsung oven error codes: meanings and safe solutions





















