Connect with us

Magazine

Electric Heater and Power Strip: Firefighters’ Advice

Plugging the heater into the wall, not a power strip, is the advice from Madrid firefighters this winter.

Published

on

Estufa eléctrica conectada directamente a un enchufe de pared en una casa

Image: Jan van der Wolf / Pexels

The Community of Madrid’s Calor Seguro campaign, run with the regional fire service, advises plugging electric heaters directly into a wall socket rather than a power strip, because of their high power demand and the risk of fire. With the cold weather arriving, the advice is relevant again for anyone using an electric heater at home. The campaign was released in October 2026.

The recommendation is among the regional fire service’s tips for using heaters, braziers and water heaters. The campaign also asks people to avoid overloading power strips and to use approved products.

Why a power strip is not suitable for a heater

A heater turns electrical energy into heat and can draw a significant amount of power while it is running. If it shares a power strip with other appliances, all of that consumption adds up on the same unit.

As an example of the calculation, a 2,000-watt heater and another 1,500-watt appliance add up to 3,500 watts. That figure does not prove the connection is safe: you would need to know the limits of every component, its condition and the installation conditions.

A power strip having several free sockets does not mean it can take everything you can plug in. Its electrical capacity is checked in its specifications, not by counting how many plugs fit. Nor is the problem solved by a power strip with more sockets or by chaining one to another: adding sockets does not in itself increase the capacity of the circuit that feeds them.

The firefighters’ recommendation is a direct connection to a suitable wall socket. If there is none within reach of where you want to put the heater, it is better to rethink the location than to improvise a chain of connections.

What to check before switching the appliance on

Before using it, check the condition of the cable and the plug. Damaged insulation, a loose connection or a damaged socket need attention before the appliance is switched on.

If there is a smell of burning, dark marks or abnormal heating at a connection, you should stop using the setup and have a professional check it. Electrical protection devices should also not be swapped for higher-rated ones to stop them tripping: if a fault keeps recurring, the cause must be identified and the installation checked.

Where to place the heater and how to use it

Curtains, clothes, blankets and furniture should not be left touching a heat source. The heater should be placed in a stable position, with its air inlets and outlets clear while it is running.

It should not be used to dry clothes or be covered with a towel, because this alters its operating conditions. It is also worth paying attention to the floor it stands on and the chance of someone knocking it as they pass: a cable crossing a walkway adds a trip hazard and tugs that can move the unit.

Supervision, bathrooms and smoke detectors

Prevention advice discourages leaving heaters unattended or running while you sleep. A timer and a tip-over protection system do not replace all other precautions.

Before using a model in the bathroom, check that the manufacturer allows that use and respect the distances and conditions indicated; it is not enough for the appliance to be small or easy to carry. The Madrid campaign also reminds people of the usefulness of fitting smoke detectors in homes as a complementary measure.

This article contains affiliate links: if you buy through them, we earn a small commission at no extra cost to you. More information.

Most read