Connect with us

Magazine

How to unlock a washing machine door with a string

The string trick, precautions and the emergency release for a washing machine door that won’t open.

Published

on

Lavadora con la puerta abierta en una cocina luminosa

Image: Tima Miroshnichenko / Pexels

To find out how to unlock a washing machine door without calling a repair technician, the string trick involves feeding a string in at the top of the door, running it round the whole circumference and, when it reaches the latch area, pulling both ends. Before trying it, switch the machine off and unplug it, check that the drum has come to a complete stop and make sure there is no water inside.

A door that stays locked at the end of the cycle and stops you taking out your washing is one of the most common washing machine problems. It does not always mean a serious fault: in some cases it can be resolved without calling a technician.

The string trick, step by step

The method comes down to three movements. First, feed a string in at the top of the door. Then run it round the whole circumference of the door. Finally, when the string reaches the latch area, pull both ends.

There is a variation using fishing line or nylon cord. Take a piece 25 to 50 cm long, slide it along the join between the door and the frame, run it round the whole door and tie it on the side opposite the lock. Pull until you hear a click, then open the door with the handle.

This method can be dangerous and should only be attempted by someone confident and experienced. It is best to wear gloves and, if you are unsure how it might affect the machine, consult the manufacturer’s manual.

What to do first: switch off, unplug and check the drum and water

Before any manual unlocking, it is essential to switch off and unplug the washing machine. Gloves and safety glasses are also recommended. As for tools, all you need is a pair of gloves, a length of rope or nylon cord, an old credit card and a screwdriver.

Make sure the drum has stopped completely and that there is no water inside. If there is a lot, you can put towels or containers under the door, or drain it by lowering the drain hose into a bucket placed lower than the door, or via the filter. Some washing machines lock automatically when they contain a lot of water.

First attempts: wait, pause and a gentle tap

The first recommended step is to unplug the machine and wait a few minutes: many doors open once the power is cut and the temperature drops. Some locks release the latch after the machine has been off for 5 minutes, and leaving it off for 5 to 10 minutes gives it time to reset, which works in most cases of a stuck lock.

If the cycle is still running, press pause (on some machines, start works as pause) and wait 1 to 2 minutes, because most locks will not open while the cycle is running. Appliance repair specialist Homer Flores notes that, on top-loading washing machines, the latches are usually heat-activated and only lock while the machine is running, so unplugging it usually solves the problem.

If the door stays shut with the machine off, gently tapping the handle with an open palm, just above the lock, may be enough to move it to the unlocked position. This is less likely to work on top-loaders.

The emergency release behind the bottom panel

Some manufacturers include an emergency release system, usually located behind the bottom panel, near the drain filter. To reach the tab, remove the bottom panel (5 to 15 cm) with a flat-head screwdriver, starting at one side rather than the centre so as not to break it.

Once the panel is off, you will find a plastic tab, often colour-coded, beneath the handle lock. Pull it down 2.5 to 7.5 cm while pulling the door handle.

On top-loading washing machines, the access panel is on the top. If the lock is magnetic, which is common on digital machines, it cannot be forced and you need to lift the top panel after removing 3 or 4 screws from the back. As these procedures vary by model, it is best to check the manufacturer’s manual first.

Other methods: an old card and the limits of each

As an alternative to the string, you can slide an old credit card or gift card between the door and the frame, near the lock, and push it towards the lock to open it. It is relatively safe and easy, but it may not work on every type of washing machine.

Why the door locks and how to prevent it

Possible causes include a faulty or blocked pressure switch, a pressure switch that does not reset, water left in the machine (sometimes fixed with a spin or drain cycle), a broken latch, handle or mechanism, or a jammed interlock.

To prevent the door locking, close it properly before starting the machine, check the seal for wear or damage and clean it regularly to remove dirt, residue or mould.

When not to force it and to call a technician

If the door does not open easily after following the steps, do not use brute force: the right thing to do is call a technician to repair the washing machine. If no method works, there may be a physical defect in the lock, and it is best to use a washing machine repair service.

This article contains affiliate links: if you buy through them, we earn a small commission at no extra cost to you. More information.

Most read