Connect with us

Magazine

Smelly washing machine: clean the seal, leave the door open

Cleaning the seal, avoiding bleach and airing the drum after each wash helps stop mould and odours in your washer.

Published

on

Técnico limpiando la junta de goma de una lavadora con la puerta abierta en una cocina luminosa

Image: Andrey Matveev / Pexels

When your washing machine smells, you should clean the rubber seal on the door and leave the door open after each wash to prevent damp, mould and bad odours. The problem is common: in a Consumer Reports survey, 16% of owners of front-loading washing machines reported problems with mould, damp and odours.

Samsung recommends leaving the door and the detergent drawer open after each wash so the appliance can dry out. Whirlpool advises leaving the door slightly open to help air circulate. Balay agrees and recommends leaving it ajar after every use.

Why the seal collects dirt

Samsung explains that the rubber seal around the door can build up moisture, lint and detergent residue. Balay describes the rubber as a spot where moisture, soap residue and lint collect, and warns that if it is not cleaned, mould can appear, odours can transfer to your clothes and there may even be water leaks caused by a poor door seal.

The same brand lists several signs that the rubber needs cleaning: black spots, a persistent bad smell, visible detergent residue and a sticky texture in the folds. It includes among the mistakes not checking the folds from time to time, where most of the dirt builds up.

How to clean the rubber seal step by step

Before starting, Balay says you should switch off and unplug the washing machine and have to hand gloves, a clean cloth, white vinegar, lukewarm water and a small brush. It suggests mixing equal parts vinegar and water, a solution that, according to the brand, is effective against mould and safe for the rubber material.

The process is as follows: open the door and gently stretch out the folds, without detaching the rubber from the drum; remove surface dirt with the cloth; apply the mixture and rub carefully. The brush is useful for hidden areas. Then rinse with a cloth dampened in clean water, dry thoroughly and leave the door open to air it. Samsung adds that you should carefully pull back the seal, clean inside the folds with a soft cloth and dry it completely.

Which products to avoid

Bosch recommends cleaning the seal with a soft, damp cloth and advises against abrasive or chlorine-based products, because they can wear down the rubber over time. Balay also warns that bleach and other harsh cleaners can damage the washing machine.

If the mould persists, Balay suggests a cleaning product that removes detergent and fabric softener residue: add the entire contents of the pack to the empty drum and run a high-temperature programme, between 90-95ºC, without a prewash.

Monthly cleaning of the drawer and drum

According to Samsung, the build-up of detergent and fabric softener in the drawer encourages bad odours. Its advice is to remove the drawer and rinse all the parts with lukewarm water about once a month. Balay also recommends a monthly clean of both the seal and the drawer.

Samsung adds that you should run the drum cleaning cycle once a month with the washing machine empty. Consumer Reports notes that residue feeds mould and advises going without fabric softener, which can leave residue.

Daily habits to prevent damp

Balay advises drying the rubber seal with a clean cloth after each wash. To prevent wear on the rubber, it recommends respecting the machine’s maximum load and using just the right amount of detergent.

This article contains affiliate links: if you buy through them, we earn a small commission at no extra cost to you. More information.

Most read